How to Read a Cut List and Sheet-Good Layout Diagram
Learn how part marks, grain direction arrows, saw kerf allowances, and board nesting diagrams work on woodworking blueprints.
Anatomy of a blueprint cut list
Every building plan in our catalog separates the shopping list (what you buy at the lumberyard) from the cut list (the finished parts you cut at the saw). Each row in the cut list carries five columns:
- Part mark (e.g., A, B, C1): Matches the callout bubble on the 3D exploded assembly drawing.
- Quantity: How many identical pieces to cut at that stop-block setting.
- Thickness × Width: Both nominal callout (such as 2×4) and actual dimensions (1-1/2 × 3-1/2 in / 38 × 89 mm).
- Length: The exact finished length in fractional inches (with quick mm conversion available in our Workshop Tools).
- Angle / Notes: Miter or bevel degrees when an end is not cut square at 90 degrees.
Accounting for saw kerf and squaring factory ends
A standard 10 in (254 mm) miter saw or circular saw blade removes roughly 1/8 in (3.2 mm) of wood with every cut. Before cutting finished parts from an 8 ft (96 in / 2,438 mm) board, trim 1/4 in (6 mm) off one factory end to establish a clean, square reference edge, then measure and cut parts sequentially rather than laying out all pencil lines at once.
Free sample blueprint
Want a sample PDF plan for your shop clipboard?
Get our free sample woodworking blueprint with dual imperial and metric measurements, cut list, and 3D assembly views sent to your email.
Get the free sample plan
